Luvion Grand Elite 2, Инструкция по эксплуатации

Страница: 11 / 86

11
LUVION
Premium Baby products
EN
3. GETTING STARTED
3.1 POWERING CAMERA UNIT
3.2 WALL MOUNTING CAMERA UNIT
1. Connect the Camera Power Adapter to the Camera Unit.
2. Slide the ON / OFF Switch to the On position. The Power LED light on the Camera
Unit will illuminate green.
3. Position your Camera Unit no less than 3 feet away from your baby’s crib. Ensure the
power cord is not within reach of your baby.
· NOTE
Only use the enclosed Camera Power Adapter (5.9V DC / 1000mA).
Before installation, check the reception and camera positioning of the location you
intend to mount the camera by holding it to the wall. Ensure the desired location is no
less than 1 meter / 3 feet away from your baby’s crib.
1. Pre-drill a hole in the wall using a 1/5 inch (6mm) drill bit.
2. Insert wall anchor into the wall and tap gently with a hammer until the anchor is
fl ush with the wall.
3. Insert screw into the wall anchor and tighten until the screw only sticks out by about
1cm / 1/3 inch.
4. Connect the Camera Power Adapter to the Camera Unit.
5. Locate the hole on the bottom of the Camera Unit and slide the hole over the screw
sticking out of the wall.
6. Check to see that the Camera Unit is secure. If it is loose, you may need to tighten
the screw more.
7. Use wall clips (not included) to secure the power cord away from the crib or baby’s
reach.