Lutz-Jesco C 7520, Руководство по эксплуатации

Страница: 15 / 36

Installation
15
© Lutz-Jesco GmbH 2021
Subject to technical changes.
210527 BA-22404-02-V03
Chlorine changeover unit
C 7520
Operating instructions
7.4.1 Terminal plan
Processor
LED
vacuum
JP5 JP3
LED
pressure
1 10 9 8 7 6 5 4 3 2 19 18 17 16 15 13 12 11 21 20 14 30 29 28 27 26 25 24 23 22
JP2
JP4
Fig. 7: Control circuit board
Terminal Description Function
1+2 N
Voltage supply input 3+4 L
5+6 PE
7 PE
Voltage supply for motor 2
(ball valve right)
8 N
9 Close
10 Open
11 PE
Voltage supply for motor 1
(ball valve left)
12 N
13 Close
14 Open
15 Com
Relay output "alarm"
max. 3 A/250 VAC
NC (15– 17 closed with power failure)
16 Off
17 On
18 Com
Relay output "empty"
max. 3 A / 250 VAC
NC (18– 20 closed with power failure)
19 Off
20 On
21 close
Position switch in motor 2
(ball valve right)
22 open
23 GND
24 close
Position switch in motor 1
(ball valve left)
25 open
26 GND
27 GasW.
Gas warning device input
closed = alarm
28 GND
Tab. 8: Terminal connection
Terminal Description Function
29 Mano.
Contact pressure gauge switch
closed = chlorine shortage
30 GND
Tab. 8: Terminal connection
7.4.2 Jumper settings
The jumpers were set voltage-free The change becomes active once the
voltage supply has been switched on.
Jumper Name
Position Function
JP1 almost closed Both motors activate at the
same time.
open (state of
delivery) The reserve battery valve opens
only after the valve of the active
battery has closed.
JP3 Pressure closed (state of
delivery) The software of the C 7520 is
activated. JP1 and JP5 must be
open.
open The software of the C 7522 is
activated.
JP 5 Rest
evacua-
tion closed Residual emptying activated
open (state of
delivery)
Residual emptying deactivated
Tab. 9: Jumper settings
JP1 (open)
JP3 (closed) JP5 (open)
Tab. 10: Mating diagram jumper
JP1