Servomotoren / Servomotors
Baugröße/Size 2 (
□
145 ) F.P 12 – 32L
Baugröße/Size 3 (
□
190 ) F.P 13 – 43L
Nr./No. 680-01975
31
5.2.13
Assemble drive end shield A (10) with screw
(25). Observe marks on drive end shield A (10)
and stator (1).
5.2.14 (FLP)
Fit resolver rotor (3) with screw (26) und spring
disk (28).
Observe marks.
5.2.14 (FAP/FIP)
Fix the encoder (3) with central screw M5-SW4
(M
Amax
= 4 Nm) in the motor shaft and tighten
the eccentric screw SW-2 (M
Amax
= 0.65 Nm).
Check the adjustment as per TM 682.117, which
can be obtained via our after-sales service;
address see chap. 9.3.
5.2.15
Fit cover (15) with
cyl. screws (23).
5.2.18
Establish electrical connections according to
terminal diagram (see Figs. 9 and 10 - FLP;
Figs.11 - FIP; Figs. 12 - FAP). Assemble back
the contact pins into the terminal box under the
assembly instruction of Messrs Intercontec.
5.2.19
Fit fitting key (41).
5.2.20
Check commutation adjustment.
Any adjustments must be made according to
adjustment instruction TM 682 117 This can be
obtained via our after-sales service; address see
Chapter 9.3.
Type with fan
5.2.16
Lay the cable to the terminal box and
Fit fan cover (100) with screw (103).
Type with oil-tight drive end shield A
5.2.17
Fit sealing ring (80) according to assembly
instruction 680-00271. This can be obtained via
our after-sales service; address, see Chapter
9.3.
5.2.22
Fit driving parts; observe information in Chapter
1.4.2.
5.2.21
Carry out high-voltage test according to VDE
0530, part 1, Section 17 and DIN VDE 0580.
