Luneau Technology Briot emotion2, Инструкция по эксплуатации, Страница: 73 / 162

Using your Edger...Special case
3-72 LTO
3.3.3.4 P
LACE A FINISHING MANUALLY
3.3.3.4.1 S
ITUATION

You wish to visualise the lens thickness and adjust the finishing position.
3.3.3.4.2 P
ROCEDURE
After opening the job and entering the characteristics, proceed as follows:
Flow chart 3-8 : Placing a finishing manually
I
MPORTANT NOTES

The finishing position can be modified in 2 ways: front/rear movement, width and depth modification (for
grooves).

Only the apex of the bevel (or the middle of the groove) is displaced. 
The opposite side remains fixed and the curve of the finishing is unchanged.

If you wish to reposition the whole finishing, move it in one direction to the required position. 
Then do the same from the opposite point.
3.3.3.4.3 S
PECIAL CASES
After the lens feeling, you may have been redirected automatically to the manual finishing screen for the following
reasons:

The bevel or the groove are outside the lens;

The bevel is too far back;

Irregular points were detected during feeling.

You may then reposition the finishing as shown in the flow chart above.
Move the finishing and position it as you wish.
Restart of feeling, 
if necessary
At the end of the second lens feeling cycle,
the manual finishing screen is displayed.
[To the rear]
[To the front]
Or
Or
Check that finishing =
After lens roughing and feeling, the manual
finishing screen is displayed.
Starting the finishing cycle once
the position has been defined