Luneau Technology Briot emotion2, Инструкция по эксплуатации, Страница: 61 / 162

Using your Edger...Usual procedure
3-60 LTO
3.2.8.5 S
UB
-
FINISHING AND ASSOCIATED PARAMETERS

The following screen is a montage to show all possible sub-finishing.
Screen 3-30 : Sub-finishing type icons

Groove/Manual Bevel 
By selecting this type of finish, you can check and reposition the bevel/the groove during the edging cycle
using a special screen which is displayed after the second lens feeling cycle.
.

Groove/Automatic Bevel 
The apex of the bevel or groove is automatically positioned at 1/3 of the lens thickness from the front face.

Groove/33% Bevel 
The apex of the bevel is positioned at 33% of the lens thickness from the front face.

Groove/50% Bevel 
The apex of the bevel is positioned at 33% of the lens thickness from the front face.

Groove/Front Face Bevel 
The bevel follows the front face of the lens and is positioned at a given distance in mm between the apex of
the bevel and the front face of the lens.

Groove/Rear Face Bevel 
The bevel follows the rear face of the lens and is positioned at a given distance in mm between the apex of
the bevel and the front face of the lens.
I
MPORTANT NOTE

If the maximum thickness of the lens is less than 2 mm, the applied bevel or groove will automatically be of
1/2 - 1/2 type, whichever type of bevel/groove is selected initially.

More information about limits: Click here or see “Points to remember”, page 78.
GROOVE
or
BEVEL
Manual
Auto
33%
50%