Lunar DPX-IQ, Руководство оператора

Страница: 71 / 166

DPX-IQ Operator’s Manual Femur B-3
• If you have the brace shown in figure B-3, position the foot brace in the center of
the scan table. Use the centerline on the scan table as a reference.
Figure B-3. Foot brace position for braces that are angled on both sides
9. Secure the patient’s feet to the foot brace.
• Do not remove the patient’s shoes.
• If you are using the brace shown in figure B-2, strap the foot of the leg to be
scanned to the angled side of the brace as shown. Make sure the ENTIRE leg is
rotated to the angle of the brace. Strap the other foot to the vertical portion of the
brace as shown.
• If you have the brace shown in figure B-3, make sure the foot brace is still
centered on the scan table. Rotate the ENTIRE leg until the foot is positioned at
an angle against the foot brace.
10. Select
!
. The scan arm and detector move to the approximate starting position and
the program turns on the laser light.
NOTE: During a DualFemur™ scan, the program scans the left femur first.
You must position the laser light for the left femur before you start
the scan.
11. Position the laser light approximately 7–8 cm below the patient's greater trochanter
where the transverse plane and the center of the leg intersect (figure B-4):
➊
laser
light position;
➋
transverse plane (Pubic Symphysis); and
➌
center of leg.
C A U T I O N
LASER RADIATION
DO NOT STARE INTO BEAM
POWER OUTPUT: 1.00 mW MAX
WAVELENGTH: 670 nm
CLASS II LASER PRODUCT
This equipment complies with
21 CFR 1040.10 and 1040.11.
WARNING:
Each Lunar scanner is equipped with a Class
II Laser that is less than 1 milliwatt in strength.
DO NOT STARE INTO THE BEAM.