Lunar Caravans 2016 Ariva, Руководство пользователя

Страница: 96 / 156

96
Defrosting
As time goes by, frost builds up on the fins
inside the refrigerator. A layer of frost thicker
on one side may occur and does not
represent a malfunction. When this layer of
frost is about 3mm thick, the refrigerator
should be defrosted.
• Switch off refrigerator.
• Remove all food and the ice cube tray.
• Leave the refrigerator door open to allow
air to enter and to prevent formation of
mildew.
• After defrosting (freezer compartment
and fins free of frost), wipe both cooling
compartments dry with a cloth.
Note: Water thawing in the main
compartment of the refrigerator runs into an
appropriate container at the back of the
refrigerator. From there the water
evaporates.
The layer of ice must never be
removed forcibly, nor may
defrosting be accelerated using a
heat source!
Gas Operation
Press button 3 . The ignition process is
activated automatically by means of an
automatic igniter.
The flame extinguishes after reaching the
preset cooling compartment temperature and
ignites again if the cooling compartment
temperature increases again. If the flame is
not lit after the first ignition attempt, the
automatic igniter repeats the ignition twice
(duration 30s) at time intervals of 2 minutes.
If the flame is not lit afterwards, a fault is
indicated.
Additional Features
The brightness of the display reduces after a
few seconds if no other buttons are pressed.
The indicator lights again if a button is
pressed. Press the button again to activate
the required function.
Failures are indicated by flashing of the
failure indicator LED.
Should the door be kept open for too long
(more than 2 minutes), an acoustic signal is
initiated (pulsing whistle tone).
Frame heating
All models are equipped with a frame heating
(12VDC/3,5W) around the freezer
compartment. During summer months with
high temperatures and humidity the metal
frame may have water droplets forming. To
evaporate these droplets switch on the frame
heating with button
5 .
The operating time of the frame heater can
be set to 2 hours, 5 hours or continuous
operation. After selecting the operating time
using button (
5 ), the temperature level
indicator ( 7 ) is extinguished for a short time
to show the set operating time for a few
seconds. The display then returns to the
temperature level indicator.
Shutting off the refrigerator
Switch off the refrigerator by pressing button
1 . Keep button 1 pressed for 3 seconds. The
display disappears and the appliance is fully
switched off.
REFRIGERATOR