Lunar Caravans 2016 Ariva, Руководство пользователя

Страница: 77 / 156

77
ELECTRICS
Warning
When Type
With pump turned on and fresh water level low
(less than 25% full)
Only available when an onboard tank is fitted
With control panel power on and leisure battery
selected (as active battery) and the voltage level
falls below 10V.
Message on screen and 30 second audible beep.
Message on screen (or flashing LED bar graph on
EC350) and 30 second audible beep.
Fresh water level low
Leisure battery voltage
low
Message on screen (or flashing LED bar graph on EC350)
and 30 second audible beep. If no action taken after 30
seconds then the system will switch the power of to
prevent severe discharge of the battery
Note: This is an emergency cut off level to protect the battery from severe damage. You should not rely on this cut off
level during normal operation, but manage your power consumption to a discharge level of 11.5V or above.
This cut off only applies to power drawn from the battery by the leisure equipment that is controlled by the control
panel power switch; it will not protect the battery from discharge by permanently connected equipment.
With control panel power on and leisure battery selected
(as active battery) and the voltage level falls below 9V.
3.6 System Warnings
The system incorporates a number of warnings that are active at specific times. These are summarised below, and also covered by relevant
sections of this manual.
Leisure battery
voltage high
With control panel power on or off and leisure battery is
selected (as active battery) and the voltage level rises
above 15.4V Message on screen (or flashing LED bar graph on
EC350) and repeated beeps from the control panel.
The beeping will not stop until the fault is cleared.
.
If the vehicle battery is selected instead of the leisure battery, then the same warnings described above for the leisure
battery are applied to the vehicle battery.
Vehicle battery
warnings
Engine running
When the engine is started the system power will be
turned off
Message on screen (EC360 only) and power button
LED flashing indicating both batteries are connected for
charging.