Lumio Crystal Touch Series, Руководство интегратора

Страница: 29 / 44

28
7.5.3.2 Connecting an Enhanced Power Source PCB Controller with a LED PCB Power
Extension
To connect an enhanced power source - PCB Controller with a LED PCB power extension:
1. Connect one end of the LED Power Control Wire to the JP3 connector on the PCB Controller , and to the
JP3 connector on the Extension PCB board on the other side.
2. Connect one end of the High Power USB Cable to the J5 connector on the PCB Controller board, and to
the J1 connector on the Extension PCB board on the other side.
Note
: The LED Power Wire and the High Power USB cable come together in a bundle.
3. Connect the 2 LED PCB Wire Extension cables to the Extension PCB board (The LED PCB wire does not
have polarity), one cable to the J3 connector, the other to the J5 connector. Connect the other side of
the LED Wire extension cables to the LED PCB Wires on the Active Barrier.
Note
: The LED Power extension cable for systems containing more than 16 LED PCBs differs from LED wires for systems
containing less than 16 LED PCBs, in that it contains 2 wires, each wire connected to the Extension PCB on side (J5, J3),
and to a connector on the active barrier on the other side. The LED Power extension cable connectors are thicker than
regular LED wires connectors.
4. Connect one end of the USB Power Cable to the CN1 connector on the Extension PCB board, and the
other end to the PC.
5. Connect the sensors to the PCB Controller (To connect sensors; see
Connecting the Sensors to the PCB
Controller on page 20
).
6. Connect one end of the Power Supply cable to the J2 connector on the Extension PCB board, and the
other side to a
5v Adaptor
connected to a wall socket power supply (110v-220v).
The following picture displays a PCB Controller connected to an Extension PCB
Figure 26 High Power PCB Controller with Extension PCB Controller