7
luminancebrands.com
Please contact 1-800-777-4440 for further assistance
ETL Model No.: CF717-2
3. Installing Hanger Ball/Downrod Assembly
(For Standard Mounting) (Continued)
HANGER BALL
DOWNROD
PIN
SET SCREW
3.6
Reinstall the Hanger Ball (Figure 6) on the Downrod
as follows . Route the 80-inch Motor Wires through
the Hanger Ball . Position the Pin through the Two
Holes in the Downrod and align the Ball so the Pin
is captured in the Groove in the top of the Hanger
Ball . Pull the Hanger Ball up tight against the Pin and
securely tighten the Set Screw in the Hanger Ball .
A loose Set Screw could create Fan wobble .
It is critical that the pin in the hanger ball is properly
installed and the setscrew securely tightened. Failure
to verify that the pin and setscrew are properly
installed could result in the fan falling.
WARNING
!
Figure 6
HANGER BALL
6 TO 9
INCHES
1/2-INCH
WHITE WIRE
BLUE WIRE
BLACK WIRE
3.7
The Fan comes with Blue, Black and White Wires that
are 80-inches long . Before installing the Fan, measure
up approximately 6 to 9-inches above top of Hanger
Ball/Downrod Assembly (Figure 7) . Cut off excess
Wires and strip back insulation 1/2-inch from end of
Wires .
Figure 7
