5
luminancebrands.com
Please contact 1-800-777-4440 for further assistance
ETL Model No.: CF717-2
IMPORTANT
Your ceiling fan is designed to be installed either in the standard manner, or in the
close-to-the-ceiling manner. Using the standard method, the hanger ball/downrod assembly will suspend
the fan several inches below the ceiling cover. Using the close-to-the-ceiling method, the ceiling cover
installs directly on the fan motor housing, thus mounting the fan 3-1/2 inches closer to the ceiling than the
standard method. In no case should the fan blades be lower than seven feet above the floor. Depending
on your desired mounting method, proceed to “3. INSTALLING HANGER BALL/DOWNROD ASSEMBLY”
for standard mounting, or to “4. INSTALLING CEILING COVER ON FAN MOTOR HOUSING” for
close-to-the-ceiling mounting.
3. Installing Hanger Ball/Downrod Assembly
(For Standard Mounting)
Figure 1
3.1
Remove the Hanger Ball by loosening the Set Screw
in the Hanger Ball until the Ball falls freely down the
Downrod (Figure 1) .
Remove the Pin from the Downrod, then remove
the Hanger Ball . Retain the Pin and Hanger Ball for
reinstallation in Step 3 .6 .
NOTE: Do not loosen the Screw holding the Green
Ground Wire.
SETSCREW
CLEVIS PIN
MOTOR
COUPLING
DOWNROD
HAIRPIN
CLIP
HAIRPIN
CLIP
MOTOR
COUPLING
SETSCREW (2)
CLEVIS PIN
DOWNROD
SET SCREWS (2)
MOTOR
COUPLER
HAIRPIN
CLIP
DOWNROD
CLEVIS PIN
Figure 2
3.2
Separate, untwist and unkink the Three 80” Motor
Wires . Route the Motor Wires through the Downrod .
Loosen the Two Set Screws preinstalled on the Motor
Coupler .
Align the Clevis Pin Holes in the Downrod with the
Holes in the Motor Coupler . Install the Clevis Pin and
secure with the Hairpin Clip (Figure 2) .
The Clevis Pin must go through the Holes in the Motor
Coupler and the Holes in the Downrod . Be sure to push
the straight leg of the Hairpin Clip through the Hole near
the end of the Clevis Pin until the curved portion of the
Hairpin Clip snaps around the Clevis Pin .
The Hairpin Clip must be properly installed to prevent
the Clevis Pin from working loose . Pull on the Downrod
to make sure the Clevis Pin is properly installed .
PHILLIPS HEAD SET SCREW
(LOOSENED)
HANGER BALL
4.5" DOWNROD
PIN
GREEN GROUND WIRE
