6
ENG
2. Mount the cable set on the ceiling
Before mounting the cable set on the ceiling / wall, it is necessary to drill holes in the ceiling (1) and install dowels (2)
(they are not in the set).When drilling holes in the ceiling / wall, pay attention to the presence of network cables to
avoid their direct damage, which can lead to an unwanted case or even an accident! After drilling the holes, it is
necessary to place dowels (2) in the holes.Secure the part of the cable set that is mounted on the ceiling (3) with the
screws (4) (not included in the set) to the ceiling. The screw (4) needs to be tightened, but not too tightly, which can
significantly weaken the connection between the dowel and the screw.
Pass the cable (7) through the cable fixing part (5) and screw this part into the part that is mounted on the ceiling (3).
The cable fixing part (5) can subsequently be used to fine-tune the height of the LED console.
For greater height adjustment, it is necessary to press the spring (6), so that the cable is unlocked and can move
again. When adjusting the height while the cables are already loaded (LED console), make sure that the cable is not
released completely. Hold the LED console with one hand, otherwise the cable may be pulled out of the cable fixing
part (5) and the LED console may fall, damage the aquarium and cause many other undesirable consequences.
Type 1
Type 2
1. Ceiling
2. Dowels
3. Ceiling mounting part
4. Screw
5. Cable securing part
6. Height adjustment spring
7. Cable
8. Carrier cap
9. Thickening on the cable
10. Sliding bracket
11. LED console body
NOTES:
• Make sure that the product is not damaged during transport.
• Adhere to standard protection measures.
• Leave the installation to a professional.
• When choosing a mounting location, pay attention to the load-bearing capacity of the ceiling / wall on which you want
to mount the LED console.
• If there is any damage to the cable set, relieve it immediately.
• Periodically check the condition of the cable set and the tightness of the screws.
• The manufacturer is not liable for any damage or malfunctions caused by incorrect installation. Contact an expert for
any installation advice.
●
Place power and mains connections in the aquarium cabinet, out of the reach of children. The power supply and
connectors must not be placed in tight spaces or covered with anything to ensure proper ventilation.
