5
510 Series Analog PTZ Camera
Physical Installation
Physical Installation
1. Attach the mount coupling to the camera. Note
that, despite its appearance, the lanyard hook
does not rotate; you can only tighten the two
hex screws.
2. Attach the lanyard to the camera and to the
mount, as shown.
3. Connect the video, power, and RS-485 cables as
needed.
4. Attach power to the camera: attach the
hot line to the red power terminal,
and the ground to the black power
terminal (refer to page 3 for
details).
5. Insert the camera into the mount
and secure it by rotating the
camera clockwise.
6. Fasten the two lock screws with
the Allen wrench.
Set the Camera Parameters
You may, if you wish, set the camera’s
channel number, protocol, and baud
mechanically, by using the DIP switches
on the camera. Setting these allows your
joystick controller to interact with the camera.
We recommend instead that you use the camera’s OSD to set these
parameters as it is much easier.
Please refer to the appendices for details on how to set the DIP
switches mechanically.
