LulzBot TAZ 3.0, Руководство пользователя

Страница: 57 / 162

4.7. REMOVE PART
(85C ABS/60C PLA)
up to printing temperature. Once the printer is at the
appropriate temperature, press the
Print
button to begin the print.
4.7 Remove Part
After the part is finished printing, the heated bed will automatically cool
down to room temperature. If you are printing PLA you will need to turn
the heated bed off. Once the bed cools you can you pop the finished part
off of the printed surface. To remove the printed part, use the clam knife
included in your printer kit. Leather gloves are suggested to protect your
hands from the clam knife blade. It is also safe practice to not place your
hand in the direction you are pushing the clam knife. Using the side of
the clam knife blade pry up one side of the printed part. If your part is
large you may need to pry at multiple points to pop the part off of the print
surface. When removing parts take caution to not damage the PET film. If
the film is cut or ripped it will peel from the glass and need to be replaced.
Make sure to reset the heated bed to the correct temperature and allow it
to heat up to the needed temperature before starting the next print.
57