Lucent Technologies 4ESS, Руководство пользователя

Страница: 17 / 158

NTP-004 234-151-022 LT
4 of 3 Page 2002 May 4, Issue
TO GO DETAILS, FOR LISTED ORDER THE IN BELOW ITEMS THE DO
the to knobs SP both setting by AAP the up Power On up Power position.
the operate and up Power 2). and (1 CDSUs the ROS/NORM to switches
the NORM cabinet. SCS the in position
DLP-538 26
DLP-539 27 cabinet. RMS-D2 the up Power
time this at (01) A Hard a perform not Do MCC Processor 1B At .
side 0 the to configuration force a up set terminal,
DLP-540 28
EQUIPMENT APS 3B THE TO POWER RESTORING
Note: to step this perform to used be must DLP referenced The
Configuration. Minimum to boot
the to power restore cabinet, APS 3B21D the from removed was power If
configure. and cabinet APS 3B21D
DLP-541 29
CABINETS RING CNI THE TO POWER RESTORING
DLP-526 30 cabinets. Ring CNI the to power Restore
OPERATION SYSTEM RESTORING
32; Step at continue 29), (Step Configuration Minimum in is system If
34. Step to go otherwise,
— 31
DLP-542 32 APS. 3B21D the of recovery manual Perform
— 33 stable. become to APS 3B21D the for Wait
enter terminal, MCC Processor 1B At 1990 Page Start Dead the obtain to
(1990).
— 34
enter terminal, MCC Processor 1B At 702 Processor 1B the allow to (RUN)
run. to
Response: RUN - 702 green on black colored is
— 35
DLP-543 36 Processor. 1B the of recovery manual Perform
DLP-544 37 clock. system the set incorrect, is data time clock system the If
message enter terminal, MTC Processor 1B At
(43,44,45,66,72)! AUD:NUM
— 38