Lucent Technologies 4ESS, Руководство пользователя

Страница: 130 / 158

234-151-022 LT DLP-541
2002 May 4, Issue 6 of 4 Page
Enter 31. y force. 0 CU the confirm to mode command in
on-line. is ROP the Ensure 32.
enter MCRT, APS 3B21D At 33. 54 APS. 3B21D the boot to mode command in
Enter 34. y boot. the confirm to
more or One RECOVERY CU OF START recover Processor printed. be will messages
first the for second per one approximately of rate a at printing be should (PRMs) messages
ROP. the at print will PRMs of pages 3 and 1 between present, are errors no If seconds. 30
Note: success: or failure of indications are following The
FAILURE: ( PRMs ..............Failing Fx3x 0 PRM )
boot the indicate messages RECOVERY" CU OF "START additional or
failing. is attempt
SUCCESS: ( PRMs ..............Successful Ex41 0 PRM 3B21D the Monitor )
Note PRMs. application and RTR passing for Check stable. is system until
ROP: 3B21D the at message following the of presence
CU RCVRY a COMPLETED
Was 35. CU RCVRY a COMPLETED successful)? was boot APS (3B21D received response
If Yes 38. Step to go ,
If No 36. Step to go ,
36. using again boot and CU APS 3B21D other the to Switch failed. attempt boot First
procedure: following the
Enter: 1. 22 secondary) to MHD change (to
Ensure SEC SET Disk. Secordary for highlighted is
Enter: 2. 11 FONL) 1 CU make (to
Enter: 3. y force) the confirm (to
Enter: 4. 54 again) boot (to
Enter: 5. y boot). the confirm (to
complete. successfully to boot or indication fail boot a for Wait 6.
Was 7. CU RCVRY a COMPLETED was boot APS (3B21D received response
successful)?
If Yes 38. Step to go ,
If No 37. Step to go ,