Network Video Recorder Quick Start Guide
16
1.
Disconnect
pluggable block
from the ALARM IN /ALARM OUT terminal block.
2.
Unfasten stop screws from the
pluggable block
, insert signal cables into slots and fasten stop screws. Ensure
signal cables are tight.
3.
Connect
pluggable block
back into terminal block.
2.3.4
Controller Connection
Figure 2. 8
Controller Connection
To connect a controller to the NVR:
1.
Disconnect pluggable block from the KB terminal block.
2.
Unfasten stop screws from the KB D+, D-
pluggable block
, insert signal cables into slots and fasten stop
screws. Ensure signal cables are in tight.
3.
Connect Ta on controller to D+ on terminal block and Tb on controller to D- on terminal block. Fasten stop
screws.
4.
Connect
pluggable block
back into terminal block.
Make sure both the controller and NVR are grounded.
Available from A1 Security Cameras
www.a1securitycameras.com email: [email protected]
Available from A1 Security Cameras
www.a1securitycameras.com email: [email protected]
