Network Video Recorder Quick Start Guide
13
Chapter 2
Installation and Connections
2.1
NVR Installation
During installation of the NVR:
1.
Use brackets for rack mounting.
2.
Ensure ample room for audio and video cables.
3.
When routing cables, ensure that the bend radius of the cables are no less than five times than its diameter.
4.
Connect the alarm cable.
5.
Allow at least 2cm (
≈0.75
-inch) of space between racks mounted devices.
6.
Ensure the NVR is grounded.
7.
Environmental temperature should be within the range of -10 to +55º C, +14 to +131º F.
8.
Environmental humidity should be within the range of 10% to 90%.
2.2
Hard Disk Installation
Before you start:
Disconnect the power from the NVR before installing a hard disk drive (HDD). A factory recommended HDD
should be used for this installation.
Tools Required: Screwdriver.
Steps:
1.
Remove the cover from the NVR by unfastening the screws on the rear and side panel.
Figure 2. 2
Remove Cover
2.
Connect one end of the data cable to the motherboard of NVR and the other end to the HDD.
Available from A1 Security Cameras
www.a1securitycameras.com email: [email protected]
Available from A1 Security Cameras
www.a1securitycameras.com email: [email protected]
