Network Video Recorder Quick Start Guide
15
2.3
Connections
2.3.1
Alarm Input Wiring
The alarm input is an open/closed relay. To connect the alarm input to the device, use the following diagram.
If the alarm input is not an open/close relay, please connect an external relay between the alarm input and the
device.
Figure 2. 6
Alarm Input Wiring
2.3.2
Alarm Output Wiring
To connect to an alarm output (AC or DC load), use the following diagram:
Figure 2. 7
Alarm Output Wiring
For DC load, the jumpers can be used within the limit of 12V/1A safely.
To connect an AC load, jumpers should be left open (you must remove the jumper on the motherboard in the
NVR). Use an external relay for safety (as shown in the figure above).
There are 4 jumpers (JP6, JP9, JP10, and JP11) on the motherboard, each corresponding with one alarm output.
By default, jumpers are connected. To connect an AC load, jumpers should be removed.
Example:
If you connect an AC load to the alarm output 3 of the NVR, then you must remove the JP 3 jumper.
2.3.3
Using Alarm Connectors
To connect alarm devices to the NVR:
Available from A1 Security Cameras
www.a1securitycameras.com email: [email protected]
Available from A1 Security Cameras
www.a1securitycameras.com email: [email protected]
