This is the fastest way to get something out from your LYNX-MIX USB Series, if you
have a keyboard and a microphone.
a. Plug the microphone into Channel 1 MIC IN.
b. Turn down AUX and LEVEL controls on the input channel.
c. Put the EQ controls on center position.
e. Turn on your LYNX-MIX USB Series.
g. If you like, you can adjust the EQ at this stage.
h. The LED on the Master LED meter should flash only occasionally, otherwise you
will hear distortion. If this LED is not active and you still hear distortion, please
turn down a little the input LEVEL control or reduce the output level of your
source instrument.
i. Connect your stereo keyboard into channel 5/6 and repeat the sequence.(for
LYNX-MIX124 USB)
Connect your stereo keyboard into channel 9/10 and repeat the sequence.(for
LYNX-MIX164 USB)
Here you are. It is your first gig with your LYNX-MIX USB Series.
f. Sing or speak into the microphone with normal volume and adjust the channel
LEVEL control of half.
3. QUICK START
Connect your stereo keyboard into channel 13/14 and repeat the sequence.(for
LYNX-MIX204 USB)
5
Sleeve=Ground/Screen
Tip=Signal
Sleeve=Ground/Screen
Ring=Return Signal (Connected together)
To Channel Insert
To Tape or FX Input
'Tapped' Connection Direct Output Lead
(Enables the Insert to be used as a Direct Output
while maintaining the channel signal flow)
Sleeve
Sleeve=Ground/Screen
Ring=Return Signal
Tip=Send Signal
To Channel Insert
To Processor Input
To Processor Output
Ring
Tip
Y-Stereo lead for insert Connection
(To be used when the processor does not employ a
single jack connection for the In/Out Connections)
USB Connection
20
5. INSTALLATION AND CONNECTION
