SPO
TLIGHT
4. CONTROL ELEMENTS
11
20 21
22 Master AUX SENDS Controls
The four controls are used to
determine the master AUX SEND
levels, which can be varied from -
to +15 dB. When the external effect
unit connected to mixer has no input
gain control, you can get a further
+15 dB gain available from these AUX
SEND outputs. As to the AUX4, it
can also provide the lovable level
adjustment for the internal effect
signal.
23 SOLO Button
The function of these SOLO buttons
are the same as the channel SOLO
button, they can also be affected
by SOLO MODE switch. Press the
SOLO button, the corresponding
AUX send will be routed to CTRL
ROOM/PHONES outputs and Meters
display.
22
23 24
24 Master STEREO AUX RETURNS Controls
These four controls set the level of effects that received from the stereo AUX
RETURN connectors, which can be varied from -
to +15 dB. They are used to
provide the further gain for low level effects.
25
25 TO AUX SEND1/2
The both rotary knobs assign the AUX RETURN signals to their respective
AUX SEND outputs: The TO AUX SEND1 assign the signal from AUX
RETURN1 to AUX SEND1 bus, and TO AUX SEND2 assign the signal from
AUX RETURN2 to AUX SEND2 bus. The adjustable range goes from -
to
+15 dB.
26
27
28
29
30
31
32
33
34
AUX RETURN3 is equipped with the MAIN MIX & CTRL/R button. Release the
button to send the stereo signal from AUX RETURN3 to MAIN MIX buses;
Engage the button, then the stereo signal will be sent to CTRL/R output.
26 MAIN MIX & CTRL/R Button
3. CONTROL ELEMENTS
SPO
TLIGHT
4. CONTROL ELEMENTS
14
39 DSP MUTE Switch & PEAK LED
This switch is used to activate/deactivate the effect facility. This LED lights up
when the input signal is too strong. In case of the digital effect module being
muted, this LED also lights up.
40 EFFECTS OUT Control
Rotate this knob to adjust the level of effect signal that intercepted from
internal DSP processor and directly sent to DFX OUT, which can be varied
from -
to +15 dB.
41 DFX2 (INT) RETURN EFFECTS TO MONITOR
The AUX1 and AUX2 controls are used to set the signal level from AUX
RETURN4, which signal will be sent to AUX SEND1 and AUX SEND2. The
adjustable range can be varied from -
to +15 dB.
42 POWER LED
The LED indicates when the Power is on in your LYNX-MIX USB S
.
eries
43 PHANTOM LED
This LED indicates when the Phantom Power is switched on.
-TAPE IN
Use the Tape input if you wish to listen to your mix
from a Tape Recorder or DAT.
- TAPE OUT
These RCA jacks will route the main mix into a tape
recorder.
44 2-TRACK IN/OUT
44
37
38
39
40 41
42 43
