Adjust this knob to select the right effect you wish to perform. There are total
16 options for you: several kinds of reverb, mono and stereo delay, effects with
modulation, and versatile two-effect combination.
37 PRESETS
38 VARIATIONS
Since you have selected the preferable effect, the next step, please go with the
fine consideration, there are also total 16 variations for each preset, and each
variation may be managed by several different factors.
SPO
TLIGHT
4. CONTROL ELEMENTS
13
after the Level control, otherwise, release the button will output the soloed
signal before the Level control. Please note that the SOLO function can never
affect the mix at main recording output, and also can't be affected by channel's
MUTE switch.
Each one of these faders will boost or attenuate (+/-15 dB) the selected frequency
at a preset bandwidth. When all the faders are in the centre position, the output
of the equalizer is flat response.
35 EQ Switch
Engage this button to add the stereo graphic EQ into the main mix output circuit.
It can be used to modify the frequency "contour" of a sound. If you release the
button free, the stereo graphic EQ will be bypassed.
36 STEREO GRAPHIC EQ
DSP SECTION
There is a powerful 24-bit/256 preset multi-effects included in your LYNX-MIX USB
Series. Effects include reverbs, chorus, flanger, delay and combinations of the above.
35
36
SPO
TLIGHT
4. CONTROL ELEMENTS
12
27 SUB1-2/SUB3-4/MAIN MIX Buttons
These three buttons are configured for AUX RETURN4, they can be regarded
as the signal assignment switches. When engaging the SUB1-2, the stereo
signal from AUX RETURN4 will be assigned to Subgroup1/2; in the same way,
SUB3-4 for Subgroup3/4, MAIN MIX for MAIN MIX buses.
28 AUX RETURNS SOLO Button
The function of AUX RETURN SOLO is like the channel SOLO button. Engaging
it sends the signal from AUX RETURN (1-4) to the CTRL OUT, PHONES outputs
and Meters display. It can also be affected by SOLO mode button, and the LED
next to the button will illuminate.
29 SUBGROUPS ASSIGN TO MAIN MIX
Through these switches, you can operate the subgroup faders as a master
control for assigning the subgroups to MAIN MIX. Engage the LEFT switch to
send the corresponding subgroup signal to MAIN MIX L, and the RIGHT switch
for MAIN MIX R. When engaging the both switches, the signal will be sent to
L/R of MAIN MIX.
30 SUBGROUPS Fader
These faders are used to control the levels of the signal send to the SUB-
GROUPS OUT, the adjustable range goes from -
to +10 dB. Any channel
that is assigned to the subgroups, not muted and not turned down will be
assigned to the SUB OUTS.
31 MAIN MIX LEVEL Fader
This fader sets the amount of signal send either to the Main Mix Output or to
the Tape Output.
32 LED Meter
The stereo 12-segment LED Meter will indicate the signal level send to the
CTRL ROOM and PHONES outputs.
33 2TK TO MIX Button
Engaging this switch allows you to combine the 2 TRACK Output with the MAIN
MIX. In other words, feeds the 2 TRACK IN signals into MAIN L/R output.
34 SOLO MODE Button
This button provides two modes: up for PFL (Pre-Fader-Listen) mode, down for
AFL (After-Fader-Listen) mode. Engage the button, the soloed signal will output
