————————————————
Accessories from
—
The Original
——
Rev. 01 15/08/2011
Page 2 of 4
The original rear mirrors need to be fitted with a relocation assy (our P/N:
130B028).
Required handlebar type: LSL Fat Bar, Type X01
Mount new handlebar into the clamps. Evenly tighten the handlebar clamps with 25Nm /
18.44lbf ft.
Mount the handlebar controls and levers as shown and install the brake and clutch units
with approximately 20mm spacing to the controls, as shown.
Assure (without brake pressure) whether the brake lever can be pulled up to the grip
and doesn’t contact the handlebar’s controls before.
Check clearance between fuel tank and handlebar as well as to the fairing; readjust handlebar
and controls if necessary.
To fit the grips, drill an end-to-end hole (4.0mm) on each side and fix the grips with the
original bolts.
ca. 20mm
