www.lsmaterials.co.kr
LSUM YJ Series
User Manual
www.lsmaterials.co.kr
6. Output terminal connection
The LSUM YJ Modules are designed to connect directly to a ring or a bus bar. The
positive and negative terminals have each hole for the screw. The positive terminal
threaded size is M8 and negative terminal is M10. Wave washers are required to ensure
long term, reliable connections.
When tightening the terminal bolt, a torque of 20N-m for the M8 bolt should be used.(30N-
m for the M10 bolt) Because the modules have a very low ESR, total ESR will be affected
by a ring lug, bus bar or torque. Therefore, it needs more attention to assemble the modules.
And appropriate protection and sealing should be used on both module terminals to avoid
shock hazards and corrosion.
7. Output connector
- The output of connector is tabulated below.
1
2
3
4
<Fig. 4> Monitoring connector
Pin #
YJ01/YJ02
YJ03/YJ04
Pin out
Signal
Pin out
Signal
Max.
current
1
TEMP
Pin1 or Pin2
TEMP
Pin1 or Pin2
-
2
TEMP
Pin2 or Pin1
TEMP
Pin2 or Pin1
-
3
Not used
-
Over
Voltage
Alarm
High-inactive
Low-active
5mA
4
Not used
-
GND
-
-
Содержание LSUM YJ Series
Страница 1: ...www lsmaterials co kr www lsmaterials co kr User Manual LSUM YJ Series ...
Страница 11: ...www lsmaterials co kr LSUM YJ Series User Manual www lsmaterials co kr Appendix I ...
Страница 12: ...www lsmaterials co kr LSUM YJ Series User Manual www lsmaterials co kr Appendix I ...
Страница 13: ...www lsmaterials co kr LSUM YJ Series User Manual www lsmaterials co kr Appendix I ...