Using the Star Pager
Charging
Any rechargeable pager will require use of an LRS charger. The Star Pager (SP4) uses the Charger 9 (CH-R9).
1. Place the pager in the charger
2. Allow unit to charge fully overnight (at least 24 hours)
3. Remove from charger, and pager will vibrate, beep, and light
4. Replace the pager in the charger at the end of each day
Messages
The pager can vibrate, beep, and light up message lights.
Vibration
• Star Pagers will vibrate a certain number of times depending on the vibe mode - V1, V2 or V3
that is selected from the transmitter keypad when sending a page
• Vibrations can be used to send additional information or to identify 1 of 3 stations
• By sending messages using vibrations, the person being paged will not have to look down to
see the lights display, instead the vibrations will let them know what station the page came from
Example:
V1 = Station 1, V2 = Station 2, V3 = Station 3
To set vibration – see p.10
LED Messaging
• The LED lights located on the front of the Star pager can be used to represent Station ID’s in lo-
cations where more than one T9601 transmitter is being used
• Each T9601 transmitter in use represents a “Station ID”
• When a page is sent, the LED lights, letting staff know which transmitter (Station ID) the page
came from
Example:
• LED 1 lights = Station 1
• LED 2 lights = Station 2
• LED 1 & 4 light = Station 5
To set LED messaging – see p.11
Programming
To program the Star Pager, see page 17.
1
2
3
4
800.437.4996
www.pager.n
et
1
4
Long Range Systems
27
T9601 User Manual
