Lowrance ELITE Ti2, Руководство по установке

Страница: 21 / 56

A fuse or circuit breaker should be fitted to the positive supply. For
recommended fuse rating, refer to
"Technical specifications"
on page 51.
Touchscreen operation in a non-marine environment
The unit is designed for operation on a vessel in the water. If you
experience any difficulties operating the touch screen with the
vessel out of the water, try the below fixes:
• If battery powered, try to power the unit from an AC to DC 12 V
power supply
• Connect an additional cable, like a transducer, to the unit and run
that cable to the floor
• Touch one of the cables connected to the unit (12 V power or
transducer) to improve the electrical reference for the touch
screen
NMEA 0183
The unit has a built in NMEA 0183 serial interface, providing both
input and output. The port(s) uses the NMEA 0183 (serial balanced)
standard, and can be configured in the software for different baud
rates up to 38,400 baud.
Talkers and listeners
Only one talker (output device) can be connected to a serial input
(RX) on the unit, in accordance with the NMEA0183 protocol.
However, an output port (TX) on the unit may be connected to up
to three listener (receiver) devices, dependent on the hardware
capabilities of the receiver.
Power connection (included cable)
A B
C
Wiring | ELITE Ti² Installation Manual
21