Lowrance ELITE Ti2, Руководство по установке

Страница: 34 / 56

Fuel remaining measurement
The Fuel remaining measurement can be determined from fuel
used by engine(s), or fuel level from tank sensors. Nominal fuel
consumption is required to set the scale on the fuel economy
gauge. This value should be determined from experience, over time.
Alternatively the boat builder or designer may be able to give an
approximate value to use.
Ú
Note:
Fuel remaining measurement taken from level sensors
while underway can get inaccurate readings due to vessel
movement.
Ú
Note:
Nominal fuel consumption setting should be determined
taking into account typical vessel loads. That is, filled fuel and
water tanks, stowed tender, supplies, etc.
Fuel flow configuration
After the number of engines is set, it is required to set which fuel
flow sensor is connected to which engine. Under Device list on the
Network page, view the Device Configuration dialog for each
sensor, and set the Location to match the engine the device is
connected to.
Unconfigure
- defaults the device which clears all user settings.
Reset Fuel Flow
- restores only the Fuel K-Value setting, if set in
Calibrate. Only Navico devices can be reset.
34
Software setup | ELITE Ti² Installation Manual