Loveshaw LD16AP, Руководство пользователя

Страница: 17 / 39

LOVESHAW an
ITW COMPANY 16
TAPE CARTRIDGE
TAPE TENSION ROLLER:
THIS ROLLER IS USED TO MAINTAIN CONSTANT TENSION ON THE TAPE THROUGHOUT THE LIFE
OF THE TAPE ROLL. TURNING THE KNURLED NUT CLOCKWISE WILL INCREASE THE TENSION;
TURNING IT COUNTERCLOCKWISE WILL DECREASE THE TENSION.
WIPE DOWN ROLLERS:
THESE RUBBER ROLLERS WIPE DOWN THE TAPE AS THE BOX PASSES THROUGH THE MACHINE.
THE PRESSURE EXERTED BY THE ROLLERS IS ADJUSTED BY CHANGING THE MAIN SPRING TO A
DIFFERENT HOLE IN THE CONNECTING LINK.
TAPE GUIDE PLATE:
THE TAPE GUIDE PLATE, ALONG WITH THE FINGER PLATE, IS USED TO FORCE THE TAPE TO
“STAND UP” FOR PROPER APPLICATION. THE TAPE GUIDE PLATE MOVES WHICH FORMS A
CORNER AS THE BOX DEPRESSES THE WIPE DOWN ROLLER ARM. THIS INSURES A SMOOTH
TIGHT TAPE APPLICATION ON THE LEADING CORNER OF THE BOX.
THE FLAT SURFACE OF THE TAPE GUIDE PLATE MUST BE TANGENT WITH THE RUBBER ROLLER
FOR PROPER OPERATION. TO MAKE ADJUSTMENTS, ROTATE THE ECCENTRIC STOP THAT IT
BEARS AGAINST.
FINGER PLATE:
THE FINGERS OF THE FINGER PLATE FORCE THE TAPE TO TAKE THE SHAPE OF THE TAPE
GUIDE PLATE. THE FINGERS SHOULD JUST MAKE CONTACT WITH THE GUIDE PLATE (TEST
THIS BY MOVING THE TAPE GUIDE PLATE - THE FINGERS SHOULD NOT MOVE WITH IT). THE
FINGERS SHOULD BE AWAY FROM THE TAPE GUIDE PLATE APPROXIMATELY 1/8”.
KNIFE ARM:
THE KNIFE ARM IS MOUNTED AT AN ANGLE TO CUT THE TAPE LIKE A SCISSORS. A STUD IS
LOCATED ON THE MOUNTING BLOCK TO PREVENT INCORRECT REPLACEMENT OF KNIFE. THE
KNIFE SHOULD BE CLEANED PERIODICALLY USING A RAG AND CLEANING FLUID. DO NOT USE
A WIRE BRUSH OR OTHER ABRASIVE DEVICE. THE KNIFE ARM SHOULD BE ADJUSTED SO THAT
THE TIPS OF THE KNIFE ARM ARE 2 ½” FROM THE CARTRIDGE FRAME. THIS CAN BE ADJUSTED
BY LOOSENING THE SMALL NUT ON THE KNIFE ARM STUD AND ROTATING HE STUD UNTIL THE
LARGE NUT CONTACTS THE BUMPER AT THE DESIRED SETTING. THE KNIFE ARM TENSION IS
CONTROLLED BY THE COMPRESSION SPRING ON THE STUD. TIGHTEN THE NYLOK NUT FOR
GREATER TENSION. ALWAYS POWER DOWN FIRST.