Setting Dwell Time
16
Setting Dwell Time
You can set the length of time (in seconds) that the receiver displays channels while in Auto
Scan.
To set dwell time:
1
.
Make sure the Wireless Receiver and
cameras are fully connected and powered
on.
2
.
Press and hold the
Pair button
and
VGA/QVGA button
at the same
until the
Dwell Time screen appears. Continue
holding both buttons.
3
.
With the Pair button and VGA/QVGA
button held down, the receiver will
automatically cycle the dwell time from
1~20 seconds. Release both buttons to set
the desired dwell time.
Note
: If you repeat this process, the Dwell
Time screen will display the last set dwell
time.
Figure 9.0 Press and hold the RES and
CH buttons at the same time
Figure 9.1 Continue holding both buttons
to set the dwell time for Auto-Scan
