Lorex L22LT11B, Инструкция по эксплуатации

Страница: 10 / 22

6
Connection instructions
CAUTION: Before installation, please make sure to power off the display and the computer or
DVR (Digital Video Recorder).
Back of PC or DVR
1 Power cord Connect one end of the power cord into the AC power connector on
the rear of the display, and the other end to an electrical wall outlet.
2 VGA cable
or
DVI Cable
Connect the signal cable:
- For analog operation use the VGA cable. Connect the VGA
signal cable to the VGA connector on the rear of the PC or DVR.
- For digital operation use the DVI-D cable. Connect the DVI-D
signal cable to the DVI connector on the rear of the monitor
and the other end to the DVI connector on the rear of the PC or
DVR. This is recommended for optimal performance.
3 Audio cable Connector one end of the audio cable to the audio-in connector on
the rear of the display, and the other end of the cable to the
audio-out jack on the PC (PC only)
4 USB cable Connect one end of the USB cable to the USB connector on the
display, and the other end of the USB cable to the PC or DVR. This is
required for touch screen operation on your PC or DVR.
Warning:
1. Please verify the videocard you are using and use an appropriate signal cable.
2. Pay attention to the PIN assignments and connection directions. Do not force to avoid bending
the pins.
VGA (D-sub 15 pin)