Look 795 LIGHT RS, Руководство пользователя

Страница: 29 / 104

27
EN
N.B. : Before going any further, you must fit the ADH2 handlebar and AEROSTEM stem (see
relevant instructions)..
Installing the routing (ctd)
7 / Position the rear derailleur cable starting from the shifter and bring it out through
⑦
(Fig. 1).
Thread over the cable the stop (C) and the liner.
8 / Overlap the liner at
⑩
(Fig. 1) by approx. 5 cm.
9 / You can add a front derailleur tensioner. In this case, cut your front derailleur casing
approx. 3 cm from where it comes out of the tube, then position the tensioner. Position the front
derailleur cable starting from the shifter and bring it out through
⑩
(Fig. 1), then install the liner
pass / angle outlet thread (D).
10 / Complete the installation.
Electrical cable routing : configuration C (AEROLIGHT) and D (LIGHT)
1 / Remove the derailleur end cap (F)
2 / Pull off the two black mechanical routing liners.
3 / Route your electrical groupset using the white pre-routing tubes and following Shimano
recommendations.
Lengths of the foam tube included in the sheath kit
Size Sort foam tube (x2) Long foam tube (x1)
XS 40 cm 50 cm
S 41 cm 51 cm
M 42 cm 52 cm
L 43 cm 53 cm
XL 44 cm 54 cm
4 / Pass the rear brake sheath (cf. § AEROLIGHT rear brake version ) in AEROLIGHT or (cf. §
LIGHT rear brake version ) in LIGHT.
5 / Refit the end cap (F) (see end stop / liner guide paragraph).
6 / If your bike is a 795 RS AEROLIGHT, pass the front brake sheath through
①
(Fig.2) (cf. fork
HSC8 EVO paragraph).