Longshine POS GT-150 Series, Руководство пользователя

Страница: 26 / 40

Hardware Setup
20
Installing a VFD
Note: Before installing a VFD, please make sure the jumper is set correctly on the main board
(Please refer to 2.2a COM power selection). The supply voltage for the customer display should be
set to +12V.
1. Turn off the system power.
2. Remove the rear plate (A). Tear off the seal on the hole and then use two screws to secure the
VFD Holder to the base.
A
3. Trace the COM cable through the VFD holder. If you are using poles, please also trace the COM
cable through the pole.