Longshine POS GT-150 Series, Руководство пользователя

Страница: 22 / 40

Hardware Setup
16
2.2d 3-in-1 Card Reader Installation…
An optional 3-in-1 Card Reader can be installed on the right side of GT-150 Terminal.
Package Content
y
A 3-in-1 Card Reader
y
A metal piece for securing 3-in-1 Card Reader
y
A cable clip
y
Screw x 4
Installing a 3-in-1 Card Reader
Note: Before installing a 3-in-1 Card Reader, please make sure the jumper is set correctly on the
main board (Please refer to 2.2a COM power selection). The supply voltage for the customer
display should be set to +5V.
1. Turn off the system power.
2. Using two screws to secure the 3-in-1 Card Reader to the metal plate.
3. Using two screws to secure the 3-in-1 Card Reader to the right side of the monitor.
4. Loosen the two screws on both sides as the picture shown below.