LOKERMANN GRAND ARC 320 CEL PFC MV, Руководство пользователя

Страница: 13 / 20

3.3
Installation
&
Operation
for TIG
Welding
3.3.1
Set up
installation
for TIG
Welding
The welding machine can be configured to communicate exclusively with wireless remote control
panel. This is done by a simple process of synchronising the wireless remote control and the machine
frequencies. Each interface frequency assigned is unique, so it is possible to use several wireless control
systems/ machines in the same area with no problems. The direct range of the machine and the
remote control.
Synchronization of the remote control with the welding machine ， follow these instructions:
1) Ensure the welding power supply is switched off.
2) Press and hold the parameter select/adjust knob on the front panel of the power supply
(2-4 seconds) while at the same time turning the machine ON using the ON-OFF switch on the
back of the welding power supply.
3) When the display on the front panel of the power supply is blank, release the control knob. Turn on
the remote control while at the same time pressing any buttons on the remote control panel or
foot pedal, the digital meter on the front panel of the welding power supply flick twice to indicate
the synchronization is successful and complete.( Synchronization has to accomplish in 10s after the
display is blank.)
4) Switch the machine off and back on again to start welding operation.
5) If the operation is unsuccessful, repeat steps 1 to 4.
6) During operation, the front panel control on the power supply is still functional but the remote
control panel has higher priority level.
7) When the remote control panel is idles for 10 seconds, it will automatically go into “sleep” mode.
8) Only front Panel Control is active when wireless remote control is in “sleep” mode. Any operation
on the wireless remote control panel will “wake it up and resumes control of the machine.
How to remove the control function of Remote control box on welding machine
1) Ensure the welding power supply is switched off.
2) Press the encoder on the front control panel of the power supply, meanwhile turn on the machine.
3) Pressing the encoder about 10 seconds, until the control panel display "rSt", then it succeed.
3.2.6
Wireless
Remote
control
Configuration