E
THERNET
N
ETWORK
C
ONFIGURATION
Before attempting to alter the Ethernet settings you should have a firm understanding of how networks function and how
each setting affects the network. It is beyond the scope of the document to provide the required documentation or
training for this complicated topic. If you are unfamiliar with network configuration, have a network professional or IT
department configure this device. Warning: Improper network settings can affect an entire network, possible rendering it
inoperable. This behavior applies to any device attached to an Ethernet network, not just an Agility Controller.
E
THERNET
N
ETWORK
S
ETTINGS
P
AGE
1. The Default button forces the network configuration back to the factory-configured settings.
2. The Agility Controller's MAC Address is shown at the bottom of the page. This is sometimes needed by IT personnel.
3. Ethernet Settings
a. Eth0 IP Address - Enter the unique IP address for this device. For example, 10.0.100.200. The default IP
address is 192.168.100.99.
b. Eth0 Subnet Mask - Enter the Subnet Mask for this device. For example, 255.0.0.0. The default Subnet Mask
is 255.255.255.0.
c. Eth0 Broadcast Mask (optional) - Enter the Broadcast Mask for this device. If unknown or not required, enter
0.0.0.0
d. Eth0 Gateway - Enter the Gateway address for this device. For example, 10.0.100.1. The default Gateway
address is 192.168.100.1.
M
ODBUS
S
UPPORT
Modbus is a de facto standard of communications commonly available in industrial control products. The Agility Controller
functions as a Modbus slave simultaneously on both the Ethernet and the isolated Com 1 RS-485 serial port.
Modbus/TCP is available on the Ethernet port on the standard port 502.
Modbus RTU is available on Com 1 isolated RS-485 serial port.
a. The serial port is configured as 9600 BPS, 8N1.
b. The ID is determined by the DIP switch settings.
The Modbus Register Map is available in the Agility Controller’s Documentation sub-menu.
S
PECIFICATIONS
1. Environmental
a. Operating Temperature -30°C - +50°C (-22°F - +122°F)
b. Operating Humidity 10% – 95% Non-Condensing
c. Dimensions 13.4"W x 13.0"H x 7.1"D
2. Power 100VAC – 125VAC, 50/60Hz 10 Amps max.
a. Agility processor – 0.5 Amps max.
b. Individual digital outputs – 1.5 Amps max.
c. Combined total digital Input/Outputs - 9.5 Amps maximum.
3. WiFi Network
a. Secure WPA2 Encryption
b. WiFi Mode:
i. Local Access Point (Hotspot) allowing access to the Agility Controller only.
ii. Client (Connect to existing WiFi network). Access is dependent on the existing network’s
configuration.
