GB - 7
PREP
AR
A
T
IO
N
CONNECTIONS
USING
THE FE
A
T
URE
S
USING
THE
D
V
D
FE
A
T
URE
S
TR
OUBLESHOO
TING
SPECIFIC
A
T
IO
N
USING THE REMOTE CONTROL
•
Point the remote control at the REMOTE SENSOR located on the unit.
•
When using this unit in a very brightly lit area, the infrared REMOTE CONTROL SENSOR may not work
properly.
•
The recommended effective distance for using the remote control is about 16 feet
(5 metres).
INSERTING BATTERIES IN THE REMOTE CONTROL
BATTERY REPLACEMENT
When the batteries become weak, the operating distance of the remote control will be greatly reduced and you
will need to replace the batteries.
Note:
• Remove the batteries from the remote control when it is not to be used for a long period. Otherwise it could
cause corrosion or battery leakage and may result in physical injury and/or property damage including fire.
• Do not mix old and new batteries. Do not mix ALKALINE, standard (CARBON-ZINC) or rechargeable (NICKEL-
CADMIUM) batteries.
• Corrosion, oxidation, battery-leakage and any other gradually acidic defect of this nature will invalidate the
guarantee.
• When discarding batteries, environmental problems must be considered and local rules or laws governing the
disposal of these batteries must be followed strictly.
CAUTION:
Danger of explosion may be resulted if batteries are incorrectly replaced. Replace only with the same or equivalent
type.
WARNING:
• Do not dispose of batteries in a fire or they may leak and/or explode.
• The battery shall not be exposed to excessive heat such as sunshine, fire or the like.
GETTING STARTED
+
_
+
_
1. Press and lift the back cover up to open the battery
compartment of the remote control.
2. Insert two AAA size batteries. Make sure to match the
(+) and (–) ends of the batteries with the (+) and (–) ends
indicated in the battery compartment. Snap the cover back
into place.
30˚
30˚
5M
