SMARTNEO-2G: CASCADING MANUAL // PAGE 21
9 ADDITIONAL INFORMATION
9.1 CHANGING A CASCADING SYSTEM
Before any changes to a Cascading System are made, ensure both Control Boxes have been disconnected
from the Power Source.
After changing a Cascading System, you may need to perform a Factory Reset. Go to Chapter 7.2 for further
instructions.
9.1.1 REPLACING A CONTROL BOX
To exchange Control Boxes in an existing Cascading System, proceed as follows:
1. Reset both Control Boxes to factory settings, see chapter 7.2. (Optional: Can also be performed
after reconnection).
2. Disconnect the Control Boxes from the power source
3. Use the instructions in Chapter 6 to connect the components to the new Control Box
9.1.2 REPLACING AN ACTUATOR
To replace Actuators in an existing Cascading System, proceed as follows:
1. Disconnect the unwanted Actuator from the Control Box
2. Connect the new Actuator to the Control Box
3. Perform a Reference Drive, see chapter 7.1
9.1.3 UNGROUPING A CASCADING SYSTEM
1. Reset the Control Boxes to factory settings, see chapter 7.2. (Optional: Can also be performed
after reconnection).
2. Disconnect the Control Boxes from the power supply
3. Disconnect the cables
9.2 MAINTENANCE
All components in the Cascading System are maintenance-free for their entire service lifetimes. If cleaning
of any product required, wipe its housing with a soft, dry cloth.
9.2.1 DISPOSAL
The SMARTneo-2G is an electrical and electronic device that must be disposed of separately
from household trash in accordance with the WEEE directive 2012/19/EU. Products of this
type are labelled with the symbol shown on the left.
Before disposing of materials and components, check their recyclability. Recycle all parts if
possible. Dispose of all materials and parts according local guidelines and regulations. Ensure
that the disposal is lastingly compatible for humans and nature.
