Logano G334X, Инструкция по установке и обслуживанию

Страница: 10 / 40

5
Tank installation
Logano G334X – 6 720 811 237 (2014/05) 10
5.3 Installing the side panels and the front boiler jacket
▶ Press insulating shields [1] into the side between the cast feet.
▶ Insert insulating blanket for the right side panel behind the gas
connector pipe.
Fig. 8 Insulating shields
[1] Insulating shield
▶ Fasten the two side panels with 2 self-tapping screws at the bottom
and one at the back of the boiler.
▶ Position the partition thermal insulation on the top at the front of the
boiler with the fabric side on the outside.
If the two hooks on the sides of the front boiler jacket are not protruding:
▶ Use a pliers to bend out the hooks on the sides of the front boiler
jacket and insert them into the oblong holes on the edges of the side
panels.
▶ Fasten the two rear tabs on the front boiler jacket to the side panels
with 2 self-tapping screws.
Fig. 9 Side panels and front boiler jacket
[1] Rear tab
[2] Side hook
[3] Side panel screws
5.4 Connecting the heating system
This section explains how the boiler is connected to the heating system.
5.4.1 Safety instructions
Fig. 10 Low water indicator
A Heating system with low water indicator
B Heating system without low water indicator
[1] Boiler
[2] Panel radiator
6 720 810 547-07.1T
1
6 720 810 547-08.1T
NOTICE: Risk of boiler damage due to moisture!
▶ Protect the individual components of the control
system and the ignition system from moisture
(dripping water, water spray, rain) during
installation, operation and servicing (e. g. pump
replacement, controller replacement, etc.).
NOTICE: Risk of system damage due to overheating as a
result of lack of water!
▶ Make sure that if the boiler is located above the level
of the heating system, it is fitted with a low water
indicator.
▶ The low water indicator must be installed when the
boiler is installed (

Fig. 10).
1
2
2
1
2
2
2
2
A
B
6 720 806 028-06.1T