LOFTNESS OS 170, Руководство пользователя и каталог запасных частей

Страница: 39 / 76

31 OS 170 Fertilizer Spreader OM
Maintenance
Removing the Rear End
The rear end can be removed if repairs, replacement, or
reconditioning should ever be needed.
To disassemble, remove the conveyor chain, bumper,
and both spinners. Locate splice pin in conveyor chain.
Remove the bolts securing the rear end.
Tightening Conveyor
1 2
3
4
Loosen nuts on the bearing mounting bolts (1) (three on
each side of conveyor).
Adjust the take-up bolt (2) and nuts (3) on both sides of
the frame evenly until conveyor chain clears frame by 1/2
in. to 1 in.
Check shaft locking collar set screws (4) for tightness
(both sides).
Reset take-up nuts (3). Tighten.
Screen Removal
The OS170 is equipped with a screen to keep debris
from falling into the hopper and conveyor.
The screen may need to be removed occasionally to
service and/or maintain the machine.
1
2
1
Remove the two bolts (1) on top of the spreader.
WARNING: The screen is heavy. It is
recommended that a power hoist be used to
lift and place the screen.
Lift screen (2) off of the spreader and set aside.
To replace the screen, reverse the steps above.
Replacing Metering Shaft
With old shaft out, install new metering shaft with handle
up and approximately 1 to 1-1/2 in. away from hopper.
Install and align sprocket with chain on gate, be sure
gate is closed all the way.
Tire Inflation
Check tire inflation pressure. Set correct inflation
pressure for tire per table.
Tire Size Inflation Pressure
11L-15 44 psi