55
For the installation anchor the cooker by using the supplied kit referring to the relevant drawing.
We provides two brackets, which will serve to anchor the wall-terminal of the cooker. We must
fix the brackets to the wall, following the instructions of the drawings. We must then slightly lift
the cooker to let in the bracket on the crease of the wall-terminal or working top cooker.
N.B. The cooker with and
without splashback must be
raised slightly in order to let the
bracket on the edge of the hob.
Note:
When the burners are alight, there must not be any
draughts inside the room in that they may affect the flame or even blow it out.
(PLEASE NOTE: The fixing hook is not provided as the type will depend on the
construction of the wall to which it will be drilled and fitted. The installer should
provide the fixing hook).
1.4.CONNECTION TO THE GAS SUPPLY: CURRENT INSTALLATION STANDARDS
The cooker should be connected according BS 6172-1990,
using either a rigid or flexible connections.
a) Class 2 (Built-in cooker sub-class 2/1): use a continuous
flexible stainless steel pipe, as per current installation
standards, which can be extended to a maximum of 2000
mm.; the ends of the pipe must be fitted with an ISO
228/1coupling and gasket or an ISO 7/1 threaded coupling
with mechanical gasket.
b) Class 1 (Free-standing cooker): Class 2 instructions also
apply. In addition, a non-metallic flexible pipe can be used
as long as it complies with current standards and the
following installation instructions are observed: the pipe must be longer than 400 mm and
shorter than 1500 mm; it must not exceed 50àC in any point; it is not pulled or twisted; it
cannot be choked and the entire edges, sharp corners or other similar hazards.
Before connecting the non-metallic flexible pipe, the pipe holder
and gasket supplied with the cooker and/or available form the reseller must be fitted to the
pipe/gas train on the back of the cooker.
ONLY FOR MODELS: XR96GV/C, XR96MF/C
Содержание 8022389009704
Страница 85: ......
