Loctite EQ RB20 500D, Руководство по эксплуатации

Страница: 80 / 126

Operating Manual
- Page 80 -
The value will be used for all lines from the current memory address forward until another Tail
Length instruction is found.
Values for the Head Time and Tail Time used when performing line dispensing are registered by
pressing the F4 key, then selecting Line Dispense Setup . The set values will be used by all lines
from that memory address forward until new set of Line Dispense Setup values are found.
Please see SECTION 8: Sample Programs for an example of the Line Dispense Setup instruction.
7.4.3 Point Dispense Setup
Registers POINT DISPENSE SETUP values which set dispensing time and waiting time at the end
of dispensing (‘tail’ time) for dots. The registered values will be used from the current memory
address forward until another POINT DISPENSE SETUP instruction is found.
The default point dispense time is set at 0.5 seconds.
7.4.4 Dispense End Setup
Dispense End Setup allows the L. Length , L. Speed and H. Speed values to be registered at a
memory address. These values will effect how far and how fast the tip rises after dispensing.
After dispensing a dot or line, it is often required to raise the tip a short distance at a slow speed.
This allows the material to cleanly break free from the tip, without ‘dragging’ material where it is
not wanted.
The distance and speed that the tip raises after dispensing is controlled by the L. Length and L.
Speed settings.
Dispenser turns Off here Tip continues moving to end of line
Tail Length