Loctite EQ RB20 500D, Руководство по эксплуатации

Страница: 52 / 126

Operating Manual
- Page 52 -
7.1.12.2 Brush Area: Circle
Brush Area Circle causes the tip to ‘paint’ the defined area by following a spiral path from the
outside limit of the circle to the center of the circle. It works in reverse of the Circle 1 function.
After registering the Brush Area Circle command, jog the tip to a point on the outside limit of the
circle to be brushed and register that location as a Line Start point. Then jog the tip directly across to
the center of the circle and register that location as a Line End point (the tip will not dispense a
straight line between these two points):
If, for example, a brush width of 5 mm was used, the tip will take the following path when the
program is run:
Closed Circle Open Circle
An open or closed option is also available for this function. Selecting the Closed option will make a
whole circle first before making the spiral. Selecting the Open option will make the spiral without
closing the outer circle.
Line Start
Paint
Area
Line End