4
1 Please Observe the Following
1.3 For your Safety
Along with the safety information presented in this manual, please refer to the Technical
Data Sheet of the respective adhesive. Download from www.loctite.com or request the
Technical Data Sheet and the Safety Data Sheet from your Henkel Technical Service.
INSTRUCTIONS given in these data sheets must be followed completely at all times!
While under warranty, the unit may be repaired by an authorized Henkel service
representative only.
Danger!
Do not look directly at LED-UV light, or at LED-UV light reflected by a reflective surface.
Doing so could cause eye damage.
Wear protective UV eyewear and protective clothing during operation and in surrounding
area. Exposure could injure the skin or eyes.
Be careful not to drop or apply shock to the EQ CL32 LED Spot. Doing so may damage
the product.
Never operate this product any way other than described in this manual. Doing so risks
exposure to LED-UV light.
Never disassemble, repair, or modify this product in any way other than specified in this
Operating Manual. Disassembling this product could cause exposure to LED-UV light,
causing eye damage or injury to the skin.
Do not expose this product to water. Do not deform, short-circuit, disassemble or modify
the lithium-ion-battery inside the product.
Follow the manufacturer
’s instructions! Request a safety data sheet for the Loctite®
product to be processed!
Any defects found must be reported immediately! Remedy any defects immediately!
Use only original replacement and spare parts. We cannot be held responsible for
damage or injury of any kind because of failure to observe the instructions in this
Operating Manual.
Comply with safety regulations according to currently valid standards!
The device may be repaired only by a Henkel authorized service.
1.4 Field of Application
The EQ CL32 LED Spot is designed for use with light cure products that cure when
exposed to ultraviolet and/or visible light.
Curing takes place when the light is directed at the liquid adhesive. The time required to
complete the curing process depends primarily on the offset distance from the UV outlet
of the device to the surface of the adhesive and the type of adhesive being used.
