Copyright © 2021, ASSA ABLOY Australia Pty Limited. All rights reserved. Reproduction in whole or
in part without the express written permission of ASSA ABLOY Australia Pty Limited is prohibited.
700002AU Rev 2 06/21
20
5831 Series
Installation and Operating Instructions
24VDC power supply must be used if Power Close,
Push and Go, or Latch Assist features are enabled .
To enable or disable any feature (factory default =
Off for all):
1 . Enter programming mode .
Press and hold both “SELECT” and “ENTER”
buttons until LEDs 1 - 4 flash green
(approximately 3 seconds) .
• Open & Close Time LED will light
2 . Press and release “SELECT” button until Options
LED lightss and LED above desired feature lights .
• PC = Power Close
• PG = Push & Go
• DB = Dynamic Braking
• LA = Latch Assist
NOTE:
Green LED indicates feature is ON .
Red LED indicates feature is OFF .
3 . Rotate thumb wheel to turn feature on or off .
4 . Press and release “ENTER” button to store
setting .
5 . Press and hold “ENTER” button for three (3)
seconds to exit programming mode .
After Installation
1 . Make sure all connections are secure .
2 . Make sure all wires are secured and hidden
where possible .
3 . Make sure controller bottom cover is installed
and secure .
4 . Make sure door, door trim surfaces,and
installation area are clean and free of debris .
5 . Make sure that customer is instructed on how to
operate product correctly and understands how
to perform daily safety check .
6 . Complete Work Order and report your actions
to Building Superintendent .
Customising Settings (Optional Features)
Figure 36
CLOSE
POSITION
OPEN
POSITION
AUTO
SETUP
OPEN & CLOSE TIME
OPEN & PWR CLOSE
FORCE
HOLD OPEN/
EXECUTIVE
OPTIONS
PG
PC
LA
DB
4
3
2
1
LEARN
RESET
SELECT
ENTER
Activation
Buttons
Thumb Wheel
Option Features
Power Close
Push & Go
Dynamic Braking
Latch Assist
