13
5831 Series
Installation and Operating Instructions
Copyright © 2021, ASSA ABLOY Australia Pty Limited. All rights reserved. Reproduction in whole or
in part without the express written permission of ASSA ABLOY Australia Pty Limited is prohibited.
700002AU Rev 2 06/21
PULL SIDE Operator and Arm Installation
Install Arm
Figure 24
WARNING:
It is a safety hazard to install arm with
battery pack connected .
1 . Install shaft extension onto pinion shaft and
tighten set screw to secure . (Figure 24)
2 . Adjust forearm length to 205mm by turning
end link clockwise or counter clockwise .
(Figure 25)
NOTE:
Arm hole will be slightly short of the
arm pivot bracket hole .
3 . With arm coupling bolts facing up and end
link hole aligned with arm pivot bracket hole,
place larger end of arm onto pinion shaft .
(Figure 26)
4 . While maintaining arm position, tighten
coupling bolts evenly (one quarter turn at
a time in a circular pattern) until
fully tight
using 3/16" hex wrench . (Figure 26)
CAUTION:
Bolts must be tightened evenly for
arm to be installed properly to operator .
5 . Push arm into arm pivot bracket to provide
tension . Secure with 5/16 - 18 flat head screw .
(Figure 26)
6 . Cycle door several times, and ensure that
door opens and closes smoothly .
Figure 25
Shaft Extension
Set Screw
End Link
205mm
Tighten each bolt 1/4 turn at a
time in a circular pattern until
all bolts are tight.
5/16 - 18
Arm Screw
Figure 26
You’ve now installed the
5831 Series, PULL SIDE Mount.
Go to “Install Battery Pack”, page 14 .
