Lochinvar EcoSword LGC 160-210 G P CE, Инструкция по установке, пусконаладке, эксплуатации и техническому обслуживанию

Страница: 64 / 94

4. Loosen the two bolts (3) to disconnect the burner engine (4) from the adapter.
5. Take the burner engine out of the water heater.
Fig. Remove the burner engine
2 1
4
3
1. Plugs on burner engine
2. Gas supply pipe
3. Bolts
4. Burner engine
Remove the burner:
6.
Loosen the four nuts (5) to disconnect the burner assembly (6) from the combustion
chamber (7).
7. Take the burner assembly out of the combustion chamber.
Caution
Be carefull, the burner can be hot.
Caution
Always replace the seal after removal of the burner.
Note
Mind the ground cable!
Fig. Remove the burner assembly
6 7
5
5
5. Nuts
6. Burner assembly
7. Combustion chamber
Disassemble the burner:
8.
Remove the flame rod (11) from the adapter (12). Do a visual check on the flame
rod.
9. Remove the hot surface igniter (10) from the adapter. Do a visual check on the hot
surface igniter.
c
n
64 Installation, Maintenance and Service part