LOAD KING 35-127 M, Руководство оператора

Страница: 56 / 216

56
35-127 M
Assembly
12� Swing jib away from boom with tag line� Control movement of the jib at all times to prevent injury
and/or equipment damage�
13� Swing jib into extended position� If it is difficult to bring the jib around you may slightly lower the
boom angle and re-attempt�
CONTROL MOVEMENT OF THE JIB
14� Due to the weight of the jib, most times it is difficult to get the top pin of the jib to the boom head
installed� Proceed with installing the lower curb side pin and retainer of the jib to boom head�
Retract the rear outrigger jack cylinders while the front outrigger arms remain fully extended� Lower
the boom so the jib head sheave can make contact with a wood block on the ground surface� This
will require the boom to be extended to reach ground level�
NOTE:
Avoid allowing the jib tp to come in contact with soft surfaces (i.e. dirt, sand or gravel) as
material can become wedged between jib tip sheave and side plates.