START UP MANUAL
3
QUICK LOAD SERVO III
Note :
To memorize
a new
parameter or
new value,
keep
[ENTER]
pressed until
the icone
disappear.
2.
SETTINGS RELATED TO INSTALLATION
2.1
End of bar
The end of bar position determines the moment when the bar feed enters the loading cycle.
Usually, the end of bar position is adjusted
as closely as possible behind the clamping
system of the lathe (approximately 5 mm or
a 1/4" behind the chuck jaws or collet
pads).
This will provide minimum bar stock
remnant.
Regardless of the length of the bars, or
parts, the end of bar position is always the
same.
In very special cases, a different end of bar
setting needs to be selected.
The length of the remnant may vary :
C
The minimum remnant length (Min)
is obtained when the feeding pusher
is just behind the clamping device
while the last part is being
machined.
C
The maximum remnant length
(Max) is obtained when there is not
enough material for machining an
additional part (Lp - 1 mm).
Maximum remnant length =
Lp - 1 mm + Min
End of bar setting :
Important :
Before handling the barfeeder, stop the lathe at the end of part cycle.
1.
Press the key
[STOP]
.
