START UP MANUAL
13
QUICK LOAD SERVO III
Note :
If the previous
profile was
"Other", a text
indicating that
the loading
table needs to
be adjusted
manually will
be displayed.
See point 4.2.
On the keypad enter [400]
Press the
[
ENTER
]
key twice; the motor (M2) engages and sets the loading table and the
loading fingers of the bar magazine. The remote command displays the following text :
On the keypad, enter [600], which represents the sum of the bar length and the thickness
of the cutoff tool.
Press the
[
ENTER
]
key twice to store the data. Press the
[ESC]
key to exit the set-up
functions.
b)
Mechanical settings :
C
Install the 25 mm diameter pusher; see point 4.1
C
If the stock is tubing, install the special adapter; see point 4.1.2
C
Check that the table and the loading fingers are in the "Profiled bars" position; see
points 4.3 and 4.4
C
Install the optional accessories for square bars (See Instruction manual, Appendices
/ Options for Quick Load Servo III)
C
Refer to Set-up for profiled bars; see point 5.2.
E N T E R O V E R A L L
P A R T L E N G T H
[ 0 . 0 0 ] I N C H E S
( I N C L U D I N G P A R T
L E N G T H , C U T - O F F T O O L
W I D T H A N D F A C E - O F F
L E N G T H )
C U R R E N T L E N G T H
* . * * * I N C H E S
