LNS Eco Load S2, Инструкция по эксплуатации

Страница: 85 / 112

CHAPTER 7: OPERATION 7-9
ECOLOAD S2
4.4. Start a new machining
Conditions must be fulfilled before proceeding automatic sequence:
1. The lathe is not in AUTOMATIC mode.
2. The lathe chuck is open.
3. The lathe stopper must be positioned at the TOP CUT position.
4. The lathe program is already set properly.
5. The bar feeder is installed and anchored.
The bar stocks are put on the magazine.
6. All parameters are set properly.
7. The bar feeder has been properly set according to pneumatics, electrics and mechanics according to
bar stock dimension and machining conditions.
8. V channel is at 15° position (SR2 ON).
Steps to set automatic sequence:
1. Manually move the lathe stopper to TOP CUT position.
2. Press until the long pusher moves back to home position (SR3 ON).
Press to raise the V channel and tilt it to 0° position (SR1 ON) for loading a new bar.
Position the short pusher at feeding position.
3. Press to move the short pusher forward for feeding the new bar out of bar feeder.
4. Press key to return short pusher to home position (SR3 ON).
5. Press to lower the V channel and tilt it to 15° position (SR2 ON).
Position the long pusher at feeding position.
6. Press until the long pusher pushes the bar stock against the stopper.
Do not release till the chuck closes.
7. Close lathe chuck.
8. Switch the bar feeder into AUTOMATIC mode by pressing and in sequence.
The related LED will ON.
9. The long pusher moves back to home position (SR3 ON).
Manually do the bar preparation on the lathe.
10. Switch the lathe to auto mode.
Never switch the bar feeder into AUTOMATIC mode the chuck is open!!!
Never switch the lathe into AUTOMATIC mode before switching the bar feeder is in
AUTOMATIC mode.